Watlow CAS200 - Manual (Page 51)

CAS200 User’s Guide Chapter 3: Using the CAS200
Watlow Anafaze 39
When you load a job, Job display shows you this screen:
If you remotely loaded the job, Job display looks like this:
If you modify a job's parameters while the job is running,
you'll see this message:
If an alarm occurs, the scanner switches to Single Channel
Display.
Change Setpoint
To change the set point, go to the Single Channel Display
of the channel you want to change, and press the Change
Setpoint key (the set point is the desired temperature, pH,
et cetera, for the process). You should see a display like
this:
• Press Yes to change the set point.
• Then press Yes or No to change the set point value.
• When you are satisfied with the set point value you
have chosen, press Enter to save your changes and
return to Single Channel Display; or
• To return to Single Channel Display without saving
your changes, press No or Back.
CHANNEL PROCESS UNITS
CHANNEL NAME ALARM STATUS
JOB 3 RUNNING
CHANNEL PROCESS UNITS
CHANNEL NAME ALARM STATUS
JOB 3 RUNNING
REMOTELY LOADED
CHANNEL PROCESS UNITS
CHANNEL NAME ALARM STATUS
JOB 3 RUNNING
DATA MODIFIED
CHANNEL PROCESS UNITS
CHANNEL NAME ALARM STATUS
03 SETPOINT ?
500 ˚ F