Watlow CAS200 - Manual (Page 24)

Chapter 2: Installation CAS200 User’s Guide
12 Watlow Anafaze
Steps Using the Collar Bracket
Installing and mounting requires access to the back of the
panel.
NOTE! Removing the scanner chassis from its case
makes mounting easier.
1. Make a panel cutout. Refer to Figure 2.3 on page 11 for
dimensions of the cutout.
2. Slide the scanner into the panel cutout.
3. Slide the mounting collar over the back of the scanner,
making sure the mounting screw indentations face
toward the back of the scanner.
4. Loosen the mounting bracket screws enough to allow
for the mounting collar and panel thickness. Place
each mounting bracket into the mounting slots (head
of the screw facing the back of the scanner). Push each
bracket backward then to the side to secure it to the
scanner case.
5. Make sure the case is seated properly. Tighten the
installation screws firmly against the mounting collar
to secure the unit. Ensure that the end of the mount-
ing screws fit into the indentations on the mounting
collar.
Figure 2.4 Mounting with the Collar Bracket
+
2
4
6
8
10
12
14
16
18
20
22
24
26
1
3
5
7
9
11
13
15
17
19
21
23
25
Adjustable
Mounting
Brackets
(top and bottom
of scanner)
Panel
Bezel Mounting Collar