Watlow CAS200 - Manual (Page 50)

Chapter 3: Using the CAS200 CAS200 User’s Guide
38 Watlow Anafaze
Press Change SP to change the setpoints.
The FUNC key is not used in normal operation. It is
reserved for future enhancement.
Single Channel Display
Single Channel display (below) shows detailed information
for one channel.
From Single Channel Display,
• Press Yes to go to the next channel.
• Press No to go to the previous channel.
• Press the Back key once to go to Job display (if it is
enabled).
• Press Enter twice to start Single Channel Scanning
display. (The Single Channel Scanning Display shows
information for each channel for one second.)
• Press any key to stop scanning mode.
Job Display
Job display appears only if:
• You have turned on the Remote Job Select function.
(This function is explained in Chapter 4: Setup.)
• You have selected a job from the job load menu.
Change SP CHNG
SP
Func
FUNC
Process Variable
Channel Number
Default Channel
Name
CHANNEL PROCESS UNITS
CHANNEL NAME ALARM STATUS
02 347 ˚F
CHAN 01
Engineering Units