XLT XD-9010B - Manual (Page 35)

35
Oven Operation
This oven is not capable of being safely placed in operation in the event of a
power failure. No attempt should be made to operate this oven during power
failure.
1. Turn the switch on. The fan(s) will energize, the temperature and conveyor control will light
up, and the conveyor will start to move.
2. Adjust the temperature controller set-point to the desired temperature. To change the oven set-
point temperature, press and hold either the UP or DOWN key. The keys needs to be de-
pressed for at least 2 seconds. After UP or DOWN key inactivity, the display will blink once
indicating that the set point temperature has been set. The FUNC and MAN keys are used at
the factory to program the variables in the controller. It is recommended that the FUNC and
MAN keys be left alone. If either of these keys has been pressed, simply press them again un-
til the display matches the Figure shown. It may take several key-presses to cycle through all
the variables.
3. Adjust the conveyor control to the desired belt time. To change the belt time, press and hold
either the UP or DOWN key.
4. To turn the conveyor ON or OFF, push both arrow keys simultaneously.
5. Allow about 30-45 seconds for the burner to ignite. You should hear combustion and see the
indicated temperature rise.
6. If the burner does not ignite, turn the switch off, wait five (5) minutes, and repeat step 1. If it
does not light after three (3) attempts, please see the troubleshooting section of this manual.
7. Allow about 30 minutes for the oven to reach the desired temperature.
8. To turn the oven off, turn the switch to the off position. Do not unplug the oven from electrical
power. The oven is equipped with an automatic cool down feature that allows the fan to run
until the oven is cooled to a safe level (approximately 30 minutes).
The Conveyor Control is factory preset at 1:30 minute minimum and 17:00 minutes
maximum. If a belt time is desired that is outside these limits, contact XLT Ovens for
proper service procedures.
CAUTION
NOTE
Conveyor Control
6:30
Belt Time
(MIN: SEC)
Up and Down
Arrow Buttons
Actual
Temperature
Set Point
Temperature
Up Key
Down Key
Temperature Control