Teledyne LeCroy SAS_SATA InFusion - Users Manual - Manual (Page 99)

SAS InFusion User Manual Version 2.0
LeCroy Corporation
85
Chapter 6: LCD Panel Menus
This chapter describes menus that appear on the LCD panel of the SAS InFusion box.
Note: As described in Chapter 2, the LCD panel displays commands for
configuring the device, and for starting and stopping scenarios.
Figure 89 SAS InFusion LCD Panel
LCD Panel Overview
If you are using the SAS InFusion box in networked mode, you typically use the LCD
panel only to set an IP address so the box can be controlled by the SAS InFusion
software application. However, if you operate SAS InFusion box in stand-alone mode,
you might continue to use the panel as the primary means to control tests (view status,
change configuration options, start and stop scenarios).
Note: Regardless if you operate in stand-alone mode or networked mode,
you must use the SAS InFusion application to create scenarios. You
can not do so using the box LCD panel.
Recall that you can download up to ten scenarios for storage on the box. To download
the scenarios, you need an Ethernet link between the box and the PC that runs the SAS
InFusion software application.
Boot Sequence
The boot sequence for the SAS InFusion box takes a few seconds. As the box boots, it
initializes itself, beeps, and shows status on the LCD panel. If the box boots successfully,
the LCD panel Root menu appears.