Teledyne LeCroy SAS_SATA InFusion - Users Manual - Manual (Page 12)

Version 2.0 SAS InFusion User Manual
xii
LeCroy Corporation
Cooling
The SAS/SATA InFusion relies on forced air cooling with internal fans and ventilation
openings. Care must be taken to avoid restricting the airflow around the apertures (fan
holes). To ensure adequate ventilation, it is required to leave a 10 cm (4 inch) minimum
gap around the sides of the instrument.
AC Power Source
The SAS/SATA InFusion operates from a single-phase, 100-240 Vrms (+/-10%) AC
power source at 50/60 Hz (+/-5%).
No manual voltage selection is required because the instrument automatically adapts to
line voltage.
Depending on the accessories installed (PC port plug-ins, etc.), the instrument can draw
up to 55 W (55 VA).
The power supply of the SAS/SATA InFusion is protected against short circuit and
overload by a 5x20 mm fuse (T1.0 A/250 V). See "Fuse Replacement" in this section for
replacement instructions.
Power and Ground Connections
The SAS/SATA InFusion is provided with a grounded cord set containing a molded
three-terminal polarized plug and a standard IEC320 (Type C13) connector for making
line voltage and safety ground connection. The AC inlet ground terminal is connected
directly to the frame of the instrument. For adequate protection against electrical shock
hazard, the power cord plug must be inserted into a mating AC outlet containing a safety
ground contact.
CAUTION
Do not block ventilation holes located on both sides of
SAS/SATA InFusion .
NOTE:
The SASInFusion/SATAInFusion automatically adapts itself to the AC
line input within the following ranges:
Voltage Range: 90 - 264 Vrms.
Frequency Range: 47-63 Hz.
WARNING
Electrical Shock Hazard!
Any interruption of the protective conductor inside or outside
of the
SAS/SATA InFusion , or disconnection of the safety
ground terminal creates a hazardous situation.
Intentional interruption is prohibited.