Teledyne LeCroy SAS_SATA InFusion - Users Manual - Manual (Page 19)

SAS InFusion User Manual Version 2.0
LeCroy Corporation
5
Ethernet
Connector
The 10/100 Ethernet host connector allows you to link the SAS InFusion box to a PC
running the SAS InFusion software application. You use this link to download scenarios.
If you choose to operate the box in networked mode, you also can use the link to control
the box across an Ethernet LAN.
Scenarios are test scripts that define how the box monitors and modifies line traffic. You
can only create scenarios on a PC running the SAS InFusion application. You can not
create scenarios via the box LCD panel.
Once you have created and downloaded scenarios to the SAS InFusion box, you can
either use the SAS InFusion software on the PC or the LCD panel on the SAS InFusion
box to select the scenario that you wish to run and to start and stop that scenario.
By default, SAS InFusion is set up to use Dynamic Host Control Protocol (DHCP). This
means that, under normal circumstances, you will not have to set an IP address and
subnet mask. If you prefer to set a static IP address, you can do so via the box LCD
panel.
If you want to eventually run SAS InFusion in stand-alone mode (without an Ethernet
connection), you can do so only after creating the scenarios on the PC and downloading
them to the box. However, once you have downloaded scenarios, you can break the
Ethernet link between the PC and box and use the box LCD panel to select and execute
a scenario.
USB
Connector
The USB connector will be enabled in a future release. It will provide an alternative to the
Ethernet port for connecting the box to a PC running the SAS InFusion application.
Power
Supply
The internal, 125 watt triple-output (+3.3V, +5V, +12V) power supply can accept 110 to
240 VAC at 50 to 60 Hz.