Laserloop error, Laserdisk early, Frame reset cmnd – Gilderfluke&Co 'Smart' Brick Animation Control System User Manual
Page 70: Call vendor, No ld in config, Stop at end cmnd, Stop command, Or dvd) player, Displayed in response to this command
(or DVD) player.
"LaserLoop Error":
Displayed if an error is encountered during a
LaserDisk (or DVD) show.
"LaserDisk early":
This is displayed if we find ourselves before the start of
the show on the LaserDisk (or DVD).
"frame reset cmnd":
Displayed in response to this command.
"call vendor":
Displayed if error occurs that requires service from the
vendor who installed your system.
"no LD in config.":
Displayed if a LaserDisk (or DVD)-based show is at-
tempted to be played while the Rack Smart Brick Brain is
in Setup mode. As the serial port is being used for the ter-
minal during Setup, it is impossible to play a LaserDisk (or
DVD)-based show during Setup.
"stop at end cmnd":
Displayed in response to this command.
"stop command":
Displayed in response to this command.
G
ILDERFLUKE
& C
O
.• 205 S
OUTH
F
LOWER
S
TREET
• B
URBANK
, C
ALIFORNIA
91502 • 818/840-9484 • 800/776-5972 •
FAX
818/840-9485
E
AST
C
OAST
/F
LORIDA
O
FFICE
• 7041 G
RAND
N
ATIONAL
D
RIVE
• S
UITE
128d • O
RLANDO
, F
L
. 32819 • 407/354-5954 •
FAX
407/354-5955
60 of 178