Gilderfluke&Co 'Smart' Brick Animation Control System - Manual (Page 68)

show", "LaserDisk show":
The shows are actually running.
" starting Smpte ":
A Smpte clocked show is being started, but the Rack
Smart Brick Brain has yet to receive any time code.
"invalid timecode":
This is displayed if the Smpte hour received doesn’t
point to a show that has been configured to run from
Smpte timecode.
"in configuration", "exited config.":
These are displayed as you enter and exit the config-
uration mode.
"+single stepping", "-single stepping":
Displayed in response to the single step serial port
commands.
"countdown hold":
This is displayed when the countdown has been
stopped by an external input.
"countdown done":
Displayed at the end of a normal countdown. About
the only time you will actually see this is if you don’t have
anything configured to happen at the end of a count-
down, or the countdown has been set to zero length
during it.
"countdown delay0":
The number of the countdown display is displayed
during normal countdowns.
G
ILDERFLUKE
& C
O
.• 205 S
OUTH
F
LOWER
S
TREET
• B
URBANK
, C
ALIFORNIA
91502 • 818/840-9484 • 800/776-5972 •
FAX
818/840-9485
E
AST
C
OAST
/F
LORIDA
O
FFICE
• 7041 G
RAND
N
ATIONAL
D
RIVE
• S
UITE
128d • O
RLANDO
, F
L
. 32819 • 407/354-5954 •
FAX
407/354-5955
58 of 178