S” (5aa5) (track#) (string) upload configuration – Gilderfluke&Co 'Smart' Brick Animation Control System User Manual
Page 52

“s” (5AA5) (track#) (string) Upload Configuration:
This command loads the string which follows it into
the configuration EEprom for the Smart Brick Brain speci-
fied by the TRACK#. This command is used to load the
configuration from another source into one or more
Smart Brick Brains in the Smart Brick System. Since the
Download Configuration command leads off its string
with a 's 5AA5', data saved in the Download
Configuration command can be reloaded into the
audio system by simply sending back to the Smart Brick
System. You have set your computer to use ACK/NAK
handshaking and it must be fast enough to respond to
this type of handshaking. If this is not possible, or if you
are having trouble getting good uploads, you can set a
‘delay between each character’ in your modem pro-
gram. This will slow the transmission down enough that
the ACK/NAK handshaking is no longer needed.
To Upload a Previously saved configuration:
1) Tell your computer to send out the previously saved
output string from the Download Configuration
command.
The Rack Brain will report on the success or failure of
the configuration upload on the LCD display (if installed)
and on the screen of the computer. The standard Smart
Brick Brain (and earlier revisions of the Rack Brain) will only
report if Interactive mode has been turned on prior to is-
suing this command.
Start Commands
“t” (track#) Start Track:
“u”
Start Global:
“v”
Start Cocked:
G
ILDERFLUKE
& C
O
.• 205 S
OUTH
F
LOWER
S
TREET
• B
URBANK
, C
ALIFORNIA
91502 • 818/840-9484 • 800/776-5972 •
FAX
818/840-9485
E
AST
C
OAST
/F
LORIDA
O
FFICE
• 7041 G
RAND
N
ATIONAL
D
RIVE
• S
UITE
128d • O
RLANDO
, F
L
. 32819 • 407/354-5954 •
FAX
407/354-5955
42 of 178