Gilderfluke&Co 'Smart' Brick Animation Control System - Manual (Page 125)

“5” Bit 5 Input Closing Edge:
“6” Bit 6 Input Closing Edge:
“7” Bit 7 Input Closing Edge:
Additional options can be set individually for the
eight inputs on the 1/4 J6 cable. The current status of
each of these inputs (either opened or closed) is also
displayed. For each input, you can select the edge to
trigger shows Sequentially, Randomly or Normally. If you
select:
a) Sequentially: If you select this option, then you are
asked for the range of shows that you want to play.
Each time this input is triggered, then the next show
in this range will be played. As an example of this, if
you select a range of shows of ten to twenty: Show
ten will be played on the first on the first edge, show
eleven on the next, etc.. After show twenty plays,
then the next show will be show ten again. Each
time this window is displayed, the ‘next’ show which
will be played on each input which has been set
for sequential operation will be displayed.
If the range of shows is just one show, then the
text displayed will show that only a single show will
be requested and played on this input.
b) Randomly: If you select this option, then you are
asked for the range of shows that you want to play
on this input. Each time this edge is triggered, one
of the shows within this range will be chosen at ran-
dom and played. As an example of this, if you se-
lect a range of shows of ten to twenty: Show ?? will
be played on the first on the first edge, show ?? on
the next, etc.. The randomizer uses a separate
counter for each of these inputs. This counts at ten
Hertz from the first show selected through the last
G
ILDERFLUKE
& C
O
.• 205 S
OUTH
F
LOWER
S
TREET
• B
URBANK
, C
ALIFORNIA
91502 • 818/840-9484 • 800/776-5972 •
FAX
818/840-9485
E
AST
C
OAST
/F
LORIDA
O
FFICE
• 7041 G
RAND
N
ATIONAL
D
RIVE
• S
UITE
128d • O
RLANDO
, F
L
. 32819 • 407/354-5954 •
FAX
407/354-5955
115 of 178