beautypg.com

X” exit setup mode, You then hit ‘any’ key – Gilderfluke&Co 'Smart' Brick Animation Control System User Manual

Page 143

background image

you then hit ‘any’ key.

“x” eXit Setup Mode:

This command is used to exit the setup mode. It is

when you exit that the Smart Brick Brain saves the check-
sums it uses to determine if the configuration has
changed. If you power down the Smart Brick Brain with-
out exiting, the Smart Brick Brain will display a ‘CS Error’
message each time it boots. To clear this, you must enter
configuration and exit again, to allow the checksum to
be calculated.

After exiting configuration for the final time, you

should move the ‘write protect’ switch to the ‘protected’
position. This will prevent any accidental or unauthorized
changes in configuration.

If you hit this command in error, hitting an

ape key will get you back to the setup mode. All
of the setup commands which don't take effect immedi-
ately, take effect when the eXit command is entered.
This includes things like the BAUD RATE, so you will have to
change the baud rate of the terminal you are using at
this time.

For compatibility with other products which might be

on the same RS-422 serial network, this command asks
you to enter a ‘Y’ or ‘N’. This lets them know that the setup
mode has been exited on this card. If you hit this com-
mand by mistake, then you can hit the ape key
to get back to where you were before.

All other Audio Repeater cards and Smart Brick Brains

in the same serial network have their serial ports disabled
while any card in the system is in setup mode. This is the
only command to which they will respond. After the initial
'X', all of the other cards wait for a 'Y' or 'N' before they will

G

ILDERFLUKE

& C

O

.205 S

OUTH

F

LOWER

S

TREET

B

URBANK

, C

ALIFORNIA

91502 818/840-9484 800/776-5972

FAX

818/840-9485

E

AST

C

OAST

/F

LORIDA

O

FFICE

7041 G

RAND

N

ATIONAL

D

RIVE

S

UITE

128d O

RLANDO

, F

L

. 32819 407/354-5954

FAX

407/354-5955

133 of 178