Gilderfluke&Co 'Smart' Brick Animation Control System - Manual (Page 119)

this time.
For compatibility with other products which might be
on the same RS-422 serial network, this command asks
you to enter a ‘Y’ or ‘N’. This lets them know that the setup
mode has been exited on this card. If you hit this com-
mand by mistake, then you can hit the ape key
to get back to where you were before.
All other Audio Repeater cards and Smart Brick Brains
in the same serial network have their serial ports disabled
while any card in the system is in setup mode. This is the
only command to which they will respond. After the initial
'X', all of the other cards wait for a 'Y' or 'N' before they will
start accepting other serial commands again. If you find
that you are having trouble communicating with any of
the cards in the system, try entering an ‘XN’ to trick it into
thinking you have exited the configuration mode.
G
ILDERFLUKE
& C
O
.• 205 S
OUTH
F
LOWER
S
TREET
• B
URBANK
, C
ALIFORNIA
91502 • 818/840-9484 • 800/776-5972 •
FAX
818/840-9485
E
AST
C
OAST
/F
LORIDA
O
FFICE
• 7041 G
RAND
N
ATIONAL
D
RIVE
• S
UITE
128d • O
RLANDO
, F
L
. 32819 • 407/354-5954 •
FAX
407/354-5955
109 of 178