W” (group) start group, Stop commands, Reset commands – Gilderfluke&Co 'Smart' Brick Animation Control System User Manual
Page 53

“w” (group) Start Group:
These commands start the animation playing on the
Smart Brick Brain(s) addressed by the command. The
shows will always start from the beginning of the show
being played. If an addressed Smart Brick Brain is cy-
cling shows, it will have its cycling mode reset. If the
Smart Brick Brain is already playing, it can be configured
to do one of the following things:
1) IGNORE THIS EARLY START.
2) SAVE THE START UNTIL THE CURRENT SHOW FINISHES AND THEN
DO IT.
3) JUMP TO THE START OF THE NEXT SHOW.
4) JUMP TO THE START OF THE CURRENT SHOW.
If the Smart Brick Brain receives a start command
after it has received a request for a specific show, it will
play that show. Requests for specific shows can come
from the serial port, J-6 PORT, and the jump forward and
jump back internal show requests (lowest priority).
Stop Commands
“x” (track#)
Stop Track:
“y”
Stop Global:
“z”
Stop Cocked:
“G” (group)
Stop Group:
These commands stop the selected Smart Brick
Brain(s) unconditionally. The stop takes place at the cur-
rent frame being played.
Reset Commands
“H” (track#)
Reset Track:
“I”
Reset Global:
“J”
Reset Cocked:
“K” (group)
Reset Group:
These commands reset the shows being played to
G
ILDERFLUKE
& C
O
.• 205 S
OUTH
F
LOWER
S
TREET
• B
URBANK
, C
ALIFORNIA
91502 • 818/840-9484 • 800/776-5972 •
FAX
818/840-9485
E
AST
C
OAST
/F
LORIDA
O
FFICE
• 7041 G
RAND
N
ATIONAL
D
RIVE
• S
UITE
128d • O
RLANDO
, F
L
. 32819 • 407/354-5954 •
FAX
407/354-5955
43 of 178