FEC DSP1500 (SAN3) - Manual (Page 87)

enFORCE
DSP1500 SAN Unit Operation Manual
PAGE 6－11 (Rev 4)
Chapter 6: System Operation
6.3.5 Press Result Display Mode
The following is displayed on the screen in the Press Result Display Mode.
The [D-NO] changes by pressing the [↑] and [↓] buttons.
D-NO DATA UNIT
＿０ Peak Load Value（Judgment Load Value） KN
＿１ Final Distance Value mm
＿２ Distance Measurement Start Load distance mm
＿３ Distance at Interference Check Load mm
＿４ 1 st Zone Operating Time Sec
＿５ Final Zone Operating Time Sec
＿６ Cycle Time Sec
＿７ Press Mode Number
＿８ Electronic Thermal Value at Operation End (Load Factor) [*100:”Load Over”]
＿９ Last 4 digits of Final Distance mm
－０ Last 4 digits of Distance Measurement Start Load distance mm
－１ Absolute Final Distance mm
－２ Last 4 digits of Absolute Final Distance mm
－３ Self Check ON: performed OFF: not performed
－４ Speed when Part Check 1 Load was Detected mm/sec
－５
Cause of press stop
0: Reset／No Data／After manual operation 1: Abnormal
2: BYPASS signal 3: STOP signal 4: REJECT
5: ACCEPT signal 6: START signal OFF 7: CW signal
8: CCW signal
－６ Load Judgment Ｌｄ Ｈ／Ｌ
－７ Distance Judgment ｄＳ Ｈ／Ｌ
－８
Work Check
0: Interference Check 1: Part Check 1 with High or Low Judgment
2: Part Check 2 with High or Low Judgment
3: Part Check 3 with High or Low Judgment
－９ Distance at Part Check 1 Load mm
＝０ Part Check 2 Minimum Load KN
＝１ Part Check 2 Maximum Load KN
＝２ Part Check 2 Distance at Minimum Load mm
＝３ Part Check 2 Distance at Maximum Load mm
＝４ Part Check 3 Minimum Load KN
＝５ Part Check 3 Maximum Load KN
＝６ Part Check 3 Distance at Minimum Load mm
＝７ Part Check 3 Distance at Maximum Load mm
＝８ Final Load KN
＝９ Distance at Judgment Load mm
「
D-NO」 「DATA」
Peak load value
Final Distance value
Distance at Judgment Load
D-NO ： Digit on the Left
０
１
9
[↑] / [↓]
buttons