FEC DSP1500 (SAN3) - Manual (Page 127)

enFORCE DSP1500 SAN Unit Operation Manual
PAGE 7－3 (Rev 4)
Chapter 7: Maintenance & Inspection
7.1.1.1 Lubrication
Recommended Schedule: 1 year or 1 million cycles minimum *
* Depending on environmental conditions, it may be required to lubricate more often. Inspect
press ram at start up for appearance of excessive lubricant deposits.
When required, lubricate according to the following guidelines:
• Use only Mobil Mobilith® SCH PM or Lube USA Luber® FS grease.
• DPT-301-** & smaller - ram must be advanced to 120mm to access ball screw through
hole.
• DPT-501-** & larger - a grease fitting is provided for ball screw nut lubrication.
• DPM-050-** - ram must be advanced to 80mm to access ball screw through hole.
• Apply 1/3 of the quantity shown. Cycle the press 3 - 4 times, then repeat.
Press Model
Gear Grease
Fitting
Gear Access Hole
Ball Screw Nut
Grease Fitting/Hole
Ram Grease
Fitting or Surface
DPT-021R*-15* 10ml. 10ml. 10ml. 10ml.
DPT-051R*-25* 10ml. 10ml. 10ml. 10ml.
DPT-101R*-25* 10ml. 10ml. 10ml. 20ml.
DPT-151R*-25* 10ml. 10ml. 10ml. 20ml.
DPT-201R*-25* 10ml. 10ml. 10ml. 20ml.
DPT-301R*-25* 10ml. 10ml. 10ml. 20ml.
DPT-501R*-25* 15ml. 15ml. 15ml. (3 fittings) 20ml.
DPT-701R*-25* 15ml. 15ml. 15ml. (3 fittings) 20ml.
DPS-101R*-20* - - 10ml. 10ml. (on surface)
DPS-301R*-20* - - 10ml. 10ml. (on surface)
DPM-050R*-10* - - 10ml. 10ml. (on surface)