FEC DSP1500 (SAN3) User Manual
Page 113

enFORCE
DSP1500 SAN Unit Operation Manual
PAGE 6-37 (Rev
4)
Chapter 6: System Operation
¾
Data Number 60 - Slow Start Time
Ramp up time value at start of cycle. [70: Slow Start Speed] is performed during Slow
Start Time.
A setting is possible from 0 to 999.9.
¾
Data Number 61 - Load Hold Time
The press will hold the [14: Target Load] or [33: Target Distance] for the amount of
time set.
If 999.9 (1 figure below the decimal) or 9999 (no decimal point) is set, Load Hold Time is
set to no limitation. It finishes operating when the START signal goes OFF.
If using the “Advanced” signal, a time must be set. The “Advanced” signal will stay on for
this set time.
A setting is possible from 0 to 999.9.
The set time for “F-type” tools should generally be kept to 1 second or
less unless duty cycle calculations have been done and the tool is
oversized for the application. If it is set and operated over 1 second,
abnormal 8-10 (overload abnormal) may occur.
The press uses [74: Press Speed 2] to control the holding of the target
load or distance. Depending on the forces acting against the press ram, if
this speed is set too fast it may cause the holding operation to fluctuate
more than desired due to reaction timing and inertia. To avoid this keep
[74: Press Speed 2] set low.
¾
Data Number 62 - Press Time (Method 5)
The amount of time the press will run after reaching [20: Time Start Load].
Operation will stop if this time is exceeded
A setting is possible from 0 to 327.6.
¾
Data Number 63 - Press Time Low Limit (Method 8)
¾
Data Number 64 - Press Time High Limit (Method 8)
In [Distance Control with Load Limit] method, this is the min. and max. time limits.
A setting is possible from 0 to 999.9.
[35]
Approach Distance
[61]
Load Hold
Time
[70] Slow Start Speed
[37] Press Speed 1 Start
Distance
Or
[16] Press Speed 1 Start Load
[60]
Slow Start Time
[33]
Target
Distance
Or
[14] Load
[73] Press Speed 1
[72] Part Search
Speed
[71] Approach Speed
[75] Decompression
Speed
Time/
Distance
[74] Press Speed 2
[38]
Press Speed 2
Start Distance
Or
[17] Press Speed 2 Start Load
[76] Return Speed
Speed
Time Settings