PASCO EM-8656 AC_DC ELECTRONICS LABORATORY - Manual (Page 101)

97
012-05892A AC/DC Electronics Laboratory
®
11
Put alligator clips on the banana plugs of both Voltage Sensors. Connect the black alligator clip
of the Voltage Sensor in Analog Channel A to the component spring at the top end of the 22 k
Ω
resistor, and the red clip to the component spring at the bottom end.
12
Connect the red alligator clip of the Voltage Sensor in Analog Channel B to the component
spring at the top end of the 1 k
Ω
resistor, and the black clip to the component spring at the
bottom end.
PART IIIA: Data Recording – ±1.5 Volts
➀ Turn on the DC power supply and adjust its voltage output to exactly +5 Volts.
➁
Turn on the power switch on the back of the power amplifier.
➂ Click the “ON” button ( ) in the Signal Generator window.
➃ Click the “REC” button ( ) to begin recording data. Recording will stop automatically after
200 samples are measured.
• Run #1 will appear in the Data list in the Experiment Setup window.
➄
Click the “OFF” button ( ) in the Signal Generator window.
➅
Turn off the power switch on the back of the power amplifier. Turn off the DC power supply.