PASCO ME-9448B Super Pulley with Clamp User Manual
Super pulley with clamp, Introduction, Usage
I n s t r u c t i o n S h e e t
012-12537A
Super Pulley with Clamp
ME-9448B
800-772-8700
www.pasco.com
®
*012-12537*
Introduction
The ME-9448B Super Pulley with Clamp is designed to be
used wherever an integral clamp that features the low fric-
tion characteristics of the PASCO Super Pulley is needed.
The clamp has two positions for attaching the Super Pulley.
The pulley can be moved from one position to the other by
removing two thumbscrews on either side of the clamp.
Once the pulley is in the desired position, replace the thumb-
screws to hold the pulley in place.
Specifications
Adjustable pulley height. Fits tables up to 1.905 cm (
3
/
4
")
thick.
Pulley:
•
Diameter = 5.1 cm (2")
•
Outside circumference = 16 cm (6.3")
•
Groove circumference = 15 cm (5.9")
•
Mass = 5 g
•
Moment of inertia (approx.) 1.86 X 10
-6
kg m
2
Helpful Hints
When using the Super Pulley with Clamp on a force table,*
keep strings as close and parallel to the surface of the table as
possible. See Figure 1..
Strings should also remain parallel when using the Super
Pulley with Clamp on inclined planes*, tracks*, or any table
that might be used for demonstration. See Figure 2.
*See the PASCO catalog or web site at www.pasco.com for
more information.
Usage
The Super Pulley with Clamp is included in several PASCO
systems and is designed to work with a variety of PASCO
equipment. The following is a list of some of the systems
and other equipment.
Thumbscrew
Thumbscrew
Super Pulley
Clamp
Figure 1
Force Table
String
Thumbscrews in
lower position
Clamp
Thumbscrews in
upper position
String
Track
Clamp
Figure 2
Friction Block
PASCO Cart