Micromod MOD: 30ML and Modcell Maintenance for 2001N, 2002N, and 1800R - Manual (Page 31)

MOD30ML and Modcell Maintenance
VIEWING DIAGNOSTIC DATA
file and then select the file. Click on the Open
button on this dialog box. shown).
The selected .MIF file name will be
displayed in the File Name field of the
dialog box (see the next figure).
Note: If you are not using the OPC Server or any other
host software package for Human System
Interface, you do not have to specify the .MIF file.
Figure 3.13. Modcell Interface File
7 Configure the serial port for the
communication: Click on the Edit – Ports button
on this dialog box. The Port Properties dialog box will be
displayed as shown below:
8 Select the COMM port from the drop-down menu
in the Port field and then enable it by checking the
box next to the Enable field.
Figure 3.14. Port Properties
9 Choose the Baud Rate, Parity, Flow Control,
Data bits and Stop bits from this dialog box. The ICN Device Properties dialog box
will redisplay with the port number.
3 -15