Meriam MFT 4010 Modular Calibrator_HART Communicator - Manual (Page 27)

22
MFT 4000 SERIES
MODEL SPECIFIC FEATURES:
MFT 4000, MFT 4005, MFT 4010
Previous sections of this manual have covered specifications and instructions that are common to all models of the
MFT. The following sections address model specific instructions.
ELECTRICAL CONNECTIONS by MFT Model
MFT 4000 Calibrator
Electrical connections are shrouded standard banana jacks (3/4” center) for ±50
mA/volts measurements.
MFT 4005 Calibrator with HART
® Trims
Electrical connections are shrouded standard banana jacks (3/4” center) for ±50
mA/volts measurements. HART
® loop connections are also standard banana jacks.
MFT 4010 Calibrator with HART
® Communications
Electrical connections are shrouded standard banana jacks (3/4” center) for ±50
mA/volts measurements. HART
® loop connections are also standard banana jacks.
For Intrinsically Safe MFT models, consult the Hazardous Area Use section
of this manual for restrictions and special instructions for use and electrical
connections.
CALIBRATE KEY – MFT 4000, 4005, & 4010
The Calibrate key provides access to powerful calibration & documentation tools. Pressing the Calibrate key
allows the user to set up the MFT to calibrate / document calibration results of HART or non-HART devices.
After pressing the Calibrate key the following screen will appear:
MFT 4005
MFT 4000
MFT 4005
MFT 4010
Cal
Cal Setup:
Begin Calibration
Procedure: Manual
Device Out: (mA)
Cal Type: P
P Meas / IV Meas
Quick Cal
Smart Trim
View Results
Clear Cal Memory
Up Down Select Back
Calibrate Key Main Menu Screen