Liquid Controls SP4000 - Manual (Page 63)

60
SP4000 Flow Computer
FLOW INPUT
6.8
FLOW INPUT
(Continued)
Enter the geometric ratio for the square law device being used. This
value is given by the manufacturer of the orifice plate, or other square
law device.
Note:
"Beta" is only required for measuring gas or steam with some
square law flowmeters.
Input:
Number with fixed decimal point: 0.0000...1.0000
Display: 1.0000
ENTER BETA
ENTER BETA
ENTER
2
RATE 1
TOTAL
CLEAR
CAL. DENSITY
Enter the calibration density. This is the fluid density upon which the
flowmeter's calibration is based.
Input:
Number with floating decimal point in requested units:
0.000...10.000
Display: 8.3372 (#/gal)
CAL. DENSITY
ENTER
2
RATE 1
TOTAL
CLEAR