Burkert Type 8136 - Manual (Page 57)

Depending on the reason for the fault and the measures taken, the
steps described in chapter "Setup" must be carried out again or must
be checked for plausibility and completeness.
9 .5 Exchanging the electronics module
If the electronics module is defective, it can be replaced by the user.
In Ex applications only one instrument and one electronics module with
respective Ex approval may be used.
If there is no electronics module available on site, one can be ordered
from the agency serving you.
9 .6 How to proceed in case of repair
If it is necessary to repair the instrument, please contact the agency
serving you.
Reaction after fault rec-
tification
LEVEL TRANSMITTER 8136 • 4 … 20 mA/HART - two-wire 57
9 Diagnosis, Asset Management and service
41783
-EN
-
120316