Burkert Type 8035 - Manual (Page 92)

90
Operatingandfunctions
→
Deducting the overfilling from the next dosing.
OVERFiLL
ALARM
+/- 0.000
→
If the overfill correction is active, enter an overfill tolerance
(value between 0.001 and 9999 dosing units) in the units
chosen at parameter "BATCH" of the sub-menu "UNIT".
→
Confirm.
DiSABLE
DiRECt
0......9
→
To deactivate the overfill correction.
→
Slightly smoothing the overfilling values of the last dosings and deducting
the calculated value from the next dosing.
LOW
→
Moderatly smoothing the overfilling values of the last dosings and
deducting the calculated value from the next dosing.
MEDiUM
→
Highly smoothing the overfilling values of the last dosings and deducting
the calculated value from the next dosing.
HiGH
RESEt Y/N
→
Reset or not the overfill correction table.
→
Confirm.
Figure 72: Configuring the overfill correction
→
If you do not want to adjust another parameter, go to the "END" parameter of the Parameters menu and press
ENTER to save the settings or not and go back to the Process level.
English
Type 8025 - 8035 BATCH