Burkert Type 8035 - Manual (Page 78)

76
Operatingandfunctions
9.7.1 Choosing the display language
When the device is energized for the first time, the display language is English.
LANGUAGE ENGLiSH
DEUtSCH
FRANçAiS
itALiANO
ESPANOL
0......9
→
Confirm the displayed language: the
selected language is immediately active.
UNit
Figure 55: Diagram of the "LANGUAGE" parameter of the Parameters menu
→
If you do not want to adjust another parameter, go to the "END" parameter of the Parameters menu and press
ENTER to save the settings or not and go back to the Process level.
9.7.2 Choosing the dosing units, the flow rate units, the units
and number of decimals of the volume or mass totalizers
When the units of the dosing quantities are changed:
• Reset both totalizers.
• Manually convert the volume or mass values in the different settings.
If, furthermore, the unit changes from "metric" to "gallon" and vice versa, convert the K factor using fol-
lowing formulae:
- K factor in pulse/US Gallon = K factor in pulse/l x 3,785
- K factor in pulse/IMP Gallon = K factor in pulse/l x 4,546
If the dosing units chosen is a mass unit, convert the K factor depending on the density of the fluid to
measure.
The number of decimals of a dosing quantity is chosen when entering the quantity.
The "UNIT" parameter allows for choosing:
• the volume or mass units of the dosing quantities.
• the flow rate units (only used to display the flow measured during a dosing).
• the units of the volume totalizers if the dosing units previously chosen is in litres, millilitres or cubic-meters.
• a number of decimals (choice 0, 1 or 2) to display the volume or mass totalizers in the Process level.
English
Type 8025 - 8035 BATCH