Burkert Type 8035 - Manual (Page 76)

74
Operatingandfunctions
8.5 %
The device shows the percentage of the quantity that has been
already dosed (symbol % blinks).
→
To read the flow rate measured in the pipe, press or
0......9
.
→
To read the total dosing quantity, press or
0......9
once.
→
To interrupt the dosing, see “Figure 53”.
→
Confirm.
BAtCH R. OK Y/N
→
Choose "OK Y" to start a new dosing.
→
Confirm.
Process level
100.4 %
When the dosing is finished:
• the display shows the reached percentage (about 100%),
• and the valves are closed.
→
To go back to the Process level in order to start a new dosing,
press
ENTER .
Figure 52: Doing a dosing, in dosing mode "LOC. REP."
→
To interrupt the dosing, press
ENTER
: the valve connected to output DO2 and possibly the valve connected
to output DO3 close, the device state LED flashes at a 1 Hz-frequency and the DO4 output (if configured to
transmit the device state, see chap. “9.7.26”) generates a 1 Hz-frequency.
CONtiNUE
0......9
RESEt
→
Confirm to continue the dosing.
→
Confirm to abort the dosing. The device goes back to the Process level.
10.2 % The counting of the dosing quantity continues.
BAtCH R. The device is ready for a new dosing.
Figure 53: Interrupting the dosing, in dosing mode "LOC. REP."
English
Type 8025 - 8035 BATCH