Burkert Type 8035 - Manual (Page 35)

33
Installationandwiring
LNLN
230V230V230V
1
A
2
3
B
C
CURRENT
SOURCE SINK
BINARY
PE PE PE
PE
DI1
DI2
DI3
DI4
DO4
ISOG
FLOW
SENSOR
L+ L- PE P- P+
NC
Iout
PULSE
DO1
Supply
12..36Vdc
Univ
Batch
(AO1)
SUPPLY
NC COIL
PULSE INPUT NPN/PN
P
2 1 3 PE
+ -
SENSOR
SUPPL
Y
LOAD
+5V
L+
(L+)-12V
COIL/PNP
39K
470
2.2K
SENSOR TYPE
COIL NPN/PNP
DO2
DO3
OFF
ON
5
6
D 7
8
4
T 125 mA
terminal block 1
PE: shieldings of the power supply cable and the input /
output cables
terminal block 2
• NC: not connected
• L+: V+ (red wire, factory wired)
• L-: 0V (black wire, factory wired)
• PE: protective earth (green/yellow wire, factory wired)
• P-: negative transistor output (DO1)
• P+: positive transistor output (DO1)
connector 3: connection of the flow sensor
terminal block 4 "binAry"
• DI1 to DI4: 4 digital inputs
• DO4: transistor output
• ISOG: ISOGND, ground common to the 4 digital inputs
and the transistor output DO4.
• PE: cable shielding
terminal block 5: wiring the DO2 relay output.
terminal block 6: wiring the DO3 relay output.
terminal block 7: wiring of the 115/230 V AC
power supply
mark 8 : time-delay fuse to protect the
115/230 V AC power supply
selector A : see chap. “7.6.4”;
selector B : see chap. “7.6.4”;
selector C : see chap. “7.6.4”.
selector D : see chap. “7.6.4”.
Figure 20: Terminal assignment of a 115/230 V AC fed compact version
English
Type 8025 - 8035 BATCH