Burkert Type 8035 - Manual (Page 46)

44
Installationandwiring
PLC
Power supply for the PLC
Position selector D depending on the value of the power supply.
230V
L N
230V
T
250 mA
5 6 7 8 9 10
L N
230V
CURRENT
SOURCE SINK
BINARY
PE PE PE
PE
DI1
DI2
DI3
DI4
DO4
ISOG
FLOW
SENSOR
L+ L- PE P- P+
NC
Iout
PULSE
DO1
Supply
12..36Vdc
Univ
Batch (AO1)
SUPPLY
NC COIL
PULSE INPUT NPN/PN
P
2 1 3 PE
+ -
SENSOR
SUPPL
Y
LOAD
+5V
L+
(L+)-12V
COIL/PNP
39K
470
2.2K
SENSOR TYPE
COIL NPN/PNP
DO2
DO3
OF
FO
N
D
+
-
+
- 5-36 VDC
Connection of the power supply
for the 8025
Figure 34: PNP wiring of the DO1 transistor output of a wall-mounted version, 115/230 V AC
→
Configure transistor output DO1 acc. to chap. “9.7.19” to “9.7.23”.
7.6.12 Wiring the relay outputs Do2 and Do3 of a compact, a
panel-mounted or a wall-mounted version
To do a dosing, connect a valve to the relay output DO2.
The device can control:
• either a dosing with a single valve connected to the relay output DO2.
• or a dosing with 2 valves connected to the relay outputs DO2 and DO3. In this case, connect the main valve
(for the highest flow rates) to output DO2 and the auxiliary valve (for low flow rates) to output DO3.
English
Type 8025 - 8035 BATCH