Burkert Type 8035 - Manual (Page 49)

47
Operatingandfunctions
9 operATinG AnD funCTions
9.1 safety instructions
Danger due to electrical voltage.
▶ Shut down the electrical power source of all the conductors and isolate it before carrying out work on the
system.
▶ Observe all applicable accident protection and safety regulations for electrical equipment.
Warning
risk of injury due to non-conforming operating.
Non-conforming operating could lead to injuries and damage the device and its surroundings.
▶ The operators in charge of operating must have read and understood the contents of these operating
instructions.
▶ In particular, observe the safety recommendations and intended use.
▶ The device/installation must only be operated by suitably trained staff.
9.2 operating levels of the device
The device has two operating levels: the Process level and the Configuration level.
The Process level allows for:
• starting a dosing.
• reading the values of the main and daily totalizers of the quantity of fluid counted since the last reset.
• reading the values of the main and daily totalizers of the done dosings since the last reset.
• resetting the daily volume or mass totalizer:
• resetting the daily totalizer of the done dosings.
• accessing the Configuration level.
The Configuration level comprises four menus (Parameters, Test, Information and History) and allow for:
• seting the device parameters.
• setting the dosing mode on the device.
• doing the Teach-In of the quantity to be dosed (only if dosing modes "LOC. REP" or "EXT. REP" are active on
the device).
• testing the inputs and the outputs of the device.
• reading and confirming, when the device state LED is orange or red and when no dosing is being done, the
warning and fault messages generated by the device.
• consulting the history of the last 10 dosings.
English
Type 8025 - 8035 BATCH