Burkert Type 8035 - Manual (Page 5)

3

9.6.7 Doing a dosing in dosing mode "LOC. REP." ..............................................................................73
9.7 Details of the parameters menu .................................................................................................................................75
9.7.1 Choosing the display language .......................................................................................................76
9.7.2 Choosing the dosing units, the flow rate units, the units and number of deci-
mals of the volume or mass totalizers ............................................................................................76
9.7.3 Entering the K factor of the fitting used ........................................................................................78
9.7.4 Determining the fitting K factor using a teach-in procedure ....................................................78
9.7.5 Configuring the dosing mode (general diagram) ........................................................................81
9.7.6 Configuring the dosing mode "LOC. MANU." .............................................................................82
9.7.7 Configuring the dosing mode "LOC. MEM." ................................................................................82
9.7.8 Configuring the dosing mode "MEM+MANU" ............................................................................82
9.7.9 Configuring the dosing mode "EXT. MEM." .................................................................................83
9.7.10 Configuring the dosing mode "EXT. +LOC" ................................................................................83
9.7.11 Configuring the dosing mode "EXT. [T]" .......................................................................................83
9.7.12 Configuring the dosing mode "EXT. REP" ....................................................................................85
9.7.13 Configuring the dosing mode "LOC. REP."..................................................................................87
9.7.14 Entering the dosing quantities in the device memory ................................................................89
9.7.15 Configuring the overfill correction or deactivating it ..................................................................89
9.7.16 Activating / deactivating the generation of alarms for problems occuring during
a dosing ................................................................................................................................................91
9.7.17 Activating / deactivating the generation of alarms for problems occuring at the
end of a dosing ...................................................................................................................................92
9.7.18 Configuring the outputs (general diagram) ..................................................................................93
9.7.19 Configuring the transistor output DO1 or DO4 or the relay output DO3 to
switch when an alarm is generated during or at the end of a dosing ....................................94
9.7.20 Configuring the transistor output DO1 or DO4 or the relay output DO3 to
switch when a warning message is emitted by the device .......................................................95
9.7.21 Configuring the transistor output DO1 or DO4 or the relay output DO3 to sig-
nal the end of the dosing ..................................................................................................................95
9.7.22 Configuring the transistor output DO1 or DO4 as a pulse output proportional
to a volume or a mass .......................................................................................................................96
9.7.23 Configuring the transistor output DO1 or DO4 to transmit the rotational fre-
quency of the paddle wheel .............................................................................................................97
9.7.24 Configuring the relay output DO2 ..................................................................................................98
9.7.25 Configuring the relay output DO3 to control an auxiliary valve ...............................................99
9.7.26 Configuring the transistor output DO4 to transmit the device state and activat-
ing / deactivating the generation of a 10 Hz frequency when an error message
is generated by the device ...............................................................................................................99
9.7.27 General diagram of the "RESET" sub-menu ............................................................................. 100
9.7.28 Resetting the two volume or mass totalizers ............................................................................ 101
English
Type 8025 - 8035 BATCH