Dynasonics DXN Portable Ultrasonic Measurement System - Manual (Page 100)

APPENDIX D: SAFETY INSTRUCTIONS
WARNING
THE INTERNAL BATTERY PACK SHOULD ONLY BE REPLACED BY AN AUTHORIZED DYNASONICS SERVICE
REPRESENTATIVE. PLEASE CONTACT YOUR PRODUCT AND/OR SERVICE PROVIDER FOR INTERNAL BATTERY
REPLACEMENT SERVICE.
Important Safety & Usage Instructions
Read these safety instructions carefully.
•
Read all cautions and warnings on the equipment.
• Place this equipment on a reliable surface when installing. Dropping it or letting it fall may cause damage.
• Make sure the correct voltage is connected to the equipment.
• For puggable equipment, the socket outlet should be near the equipment and should be easily accessible.
• If equipment has reached its end of life, please recycle properly.
• Disconnect this equipment from the AC outlet before cleaning it. Use a moist cloth. Do not use liquid or spray detergent
for cleaning.
• To fully disengauge the power to the unit, disconnect the power from the AC outlet.
• Do not scratch or rub the screen with a hard or sharp object.
• Never use any of the solvents, such as thinner spray-type cleaner, wax, benzene, abrasive cleaner, acid or alkaline solvent,
on the display. Harsh chemicals may cause damage to the enclosure and the touch screen sensors.
• Remove dirt with a lightly moistened cloth. Then wipe the enclosure with a soft dry cloth.
• The fins on the enclosure are for air convection and protect the equipment from overheating.
• DO NOT COVER THE OPENINGS.
• Position the power cord so that cannot be stepped on. Do not place anything over the power cord.
• If the equipment will not be used for a long time, disconnect it from the power source to avoid damage by transient over-
voltage.
• Never pour any liquid into openings. This may cause fire or an electrical shock.
• Never open the equipment. There are no user serviceable parts inside. For safety reasons, the equipment should be
opened only by qualified service personnel.
• If one of the following situations arises, get the equipment checked by service personnel:
•
The power cord or plug is damaged.
• Liquid has penetrated into the equipment.
• The equipment does not work properly, or you cannot get it to work according to the user’s manual.
• The equipment has been dropped or damaged.
• The equipment has obvious signs of breakage.
DXN Portable Ultrasonic Measurement System
Page 100 February 2013