Datamax-O'Neil DPL Programmer’s Manual - Manual (Page 9)

Overview
1
1 Overview
Who Should Use this Manual
This manual is intended for programmers who wish to create their own label production
software.
The Scope of this Manual
This manual, arranged alphabetically by command, explains Datamax-O’Neil Programming
Language (DPL) and its related uses in the writing, loading and storing of programs for the
control and production of label formats (designs) for the following printers at, or above, the
listed firmware version below:
Printer Firmware Version
E-Class Mark III Basic and Advanced Models
Serial# 4xxxxxxx or greater or Firmware
Version 9.04_0001 or greater
E-Class MARK III Pro/Pro+ All
I-Class Mark II All
RL3 & RL4 All
Model distinctions, including configurations and equipment types be indicated in this text to
differentiate command compatibility. The appendices of this manual also contain details that
cannot be ignored; the use of any command will require checking for possible exclusionary
conditions.

• See the KC command for information regarding attainment of the printer’s firmware
version; and then, if necessary, upgrade that firmware. Upgrades are available at
http://www.datamax-oneil.com .
• Programming information for older Class Series printers Class Series II Programmer’s
Manual (part number 88-2341-01). All manuals can be downloaded from our web site at
http://www.datamax-oneil.com .
• References to “Menu Settings” refer either to the set-up menu or to the system menu of
the printer; consult to the appropriate Operator’s Manual for details.
• Where applicable, printer responses to a host device will depend upon the communication
port, port settings, and cabling.