Datamax-O'Neil DPL Programmer’s Manual - Manual (Page 40)

System-Level Command Functions
32
STX Z Print Configuration Label
This command causes the printer to produce a Database Configuration Label. To capture
all printed information, use the labels as wide as the maximum print width (see
Appendix K) and at least four inches (102 mm) long.
Syntax:
Z
Printer response:
MODE:
DISABLED
BACKUP DELAY (1/50s):
0
FONT EMULATION:
STANDARD FONTS
LABEL STORE:
STATE & FIELDS
MENU LANGUAGE:
ENGLISH
FAULT HANDLING:
LEVEL:
STANDARD
VOID DISTANCE:
0.50 in.
RETRY COUNT:
1
BACKFEED ON CLEAR:
DISABLED
COMMUNICATIONS
SERIAL PORT A:
BAUD RATE:
9600 BPS
PROTOCOL:
BOTH
PARITY:
NONE
DATA BITS:
8
SYSTEM INFORMATION
PRINT BUFFER SIZE:
100 in.
FLASH SIZE:
8 MB
RAM TEST:
PASS
CONFIGURATION
TUE 09:09 AM 10FEB2009
PRINTER KEY:
4212-HE25-060224-090
APPLICATION VERSION:
83-2541-11H3 11.083 12/22/2008
MCL Version: 1.00.06-072
BOOT LOADER:
83-2539-11A 11.01 10/02/2007
UNLOCKED:
CG TIMES
FPGA:
HP10
iPH:
5x-00289 #163
MACM:
00-0d-70-03-8b-b9
MACO:
NOT SET
MACR:
00-90-c9-01-D0-64

Printed information will vary according to printer, model, firmware version, and options.
STX z Pack Module
Ignored.
This command causes the printer to reclaim all storage space associated with all deleted
files on the specified module (see X and x).
Syntax:
zm
Where:
m
- The module identification character; see Appendix K.

ignored