Datamax-O'Neil DPL Programmer’s Manual - Manual (Page 122)

Label Formatting Command Functions
114
c Set Cut by Amount
This command is the same as the “:” command except only a two-digit value can be
entered. This command allows a predetermined number of labels to be printed before a
cut is initiated. 1 to 99 labels may be printed before a cut is made.
Syntax:
cnn
Where:
nn
- Is a two-digit number indicating the number of labels
to be printed before a cut is performed. The default is
one.
Sample
L
c07
141100001000100SAMPLE LABEL
Q0021
E
The sample above instructs the printer to make cuts after labels
7, 14, and 21 have been printed. See Label Formatting Command
“:”.

The cutter must be enabled and all mechanism interlocks closed for the cut operation.
D Set Dot Size Width and Height
This command is used to change the size of a printed dot, hence the print resolution –
dots per inch (DPI) of the print head. By changing the height of a dot, the maximum
length of a label can be increased or decreased. For the element sizes see Appendix K.
Syntax: Dwh
Where: w - Is Dot Width multiplier 1 or 2.
h - Is Dot Height multiplier 1, 2, or 3.

D11 is the default value for 300, 400 and 600 DPI printer models, while D22 is the
default value for all 203 DPI printer models.