Datamax-O'Neil DPL Programmer’s Manual - Manual (Page 72)

Extended System-Level Command Functions
64
(FH) Fault Handling – This command determines the level of user intervention and
the disposition of the label being printed when a fault condition (ribbon out, media
out, etc.) occurs.
Value
Units /
Interpretation
Selection / Definition
L
0 = No Reprint
Printing stops and a fault message is displayed. After the
problem is corrected, the FEED Key must be pressed to
clear the fault. The label in process is not reprinted.
1 = Standard
Printing stops and a fault message is displayed. After the
problem is corrected, the FEED Key must be pressed to
clear the fault. The label in process is reprinted.
2 = Void and
Retry
Depending upon the RETRY COUNT, one of the following
actions when faulted:
• If the Retry Count has not been exceeded, “VOID” is
printed on the label in process and reprinting occurs
automatically;
• If the Retry Count has been exceeded, printing stops and
a fault message is displayed. After the problem is
corrected, the FEED Key must be pressed to clear the
fault. The label in process is reprinted; or,
• If the CANCEL Key is pressed, the operator now has the
option of canceling the reprint. To allow reprinting, press
the ESCAPE Key; or, to cancel reprinting, press the
ENTER Key (and, the entire label batch will be cancelled
by pressing the ENTER Key again).

VOID will not be printed when insufficient text space
exists (see VOID DISTANCE, below) or if the fault
occurs after the label reaches its Present Distance
at, or above, the TOF.
(continued)