Datamax-O'Neil DPL Programmer’s Manual - Manual (Page 117)

Extended System-Level Command Functions
109
STX Ky Download Plug-in File
This command allows to download a plug-in file to the specified module from the host to
the printer. The data that immediately follows the command string will be plug-in data.
This command is internal to D-O only.
Syntax: KymNamedata
Where: m - Valid Module ID – Range A to Z
Name - Up to 16 characters used as plug-in file name.
data -
Plug-in data
Sample:
KyXPlugin1data...data
The sample above instructs the printer to (1) receive Plug-in file
data sent by the host, (2) name the image “Plugin1”, and (3)
store it in Module X (with a .dim file extension).
STX KZ Immediately Set Parameter
This command immediately sets the specified parameter.
Syntax:
KZax
Where:
a
- Valid parameter identifier, as follows:
F = Feed Speed
P = Print Speed
S = Slew Speed
H = Heat Setting
x - Speed Parameter Range – A to e (see Appendix L).
-or-
xx
- Heat Parameter Range – A two-digit value (00-30);
see the “H” Label Formatting Command.
Sample: KZH22
The sample above causes the file currently being executed to
assume a Heat Value of 22.