Datamax-O'Neil DPL Programmer’s Manual - Manual (Page 62)

Extended System-Level Command Functions
54
Kc Parameter Overviews
(AL) Alignment Length – This command, critical for small labels when Label
Alignment is set to YES, allows a length (measured from leading edge to leading
edge of two successive labels) to be entered. The measured length must be provided
to the nearest hundredth of an inch. For very small labels, errors of 0.01” can result
in noticeable print variations on the labels between the media sensor and the print
head. The number of labels that can be fit between the Media Sensor and the print
head will magnify any error in label alignment length. Errors in measurement are
more favorable on the low side rather than the high side.
(AS) Single Byte Symbol Set – This command allows for a default single-byte
symbol set. See y or ySxx for command details.
(AV)Avalanche Enabled Parameters – This command allows the printer to be
configured for the Avalanche utility..
Syntax:
KcAV[nnn
1
,vvvv
1
:nnn
2
,vvvv
2
:…,nnn
n
,vvvv
n
:];
Where:
nnn
i
,vvvv
i
: Configuration Item – Value pairs
nnn
i
Decimal Item Numbers from 1 to 9999
, Decimal Item Number Delimiter
vvvv
i
Item Value (syntax defined later)
: Item Value Delimitermimitd
Example – Turn the Avalanche Enabler on:
KcAV[1,1:2,’192.168.99.1’:4,’Ava.Do.local’:8,b:9,10]
Enable Avalanche Enabler, Agent IP address is 192.168.99.1, Agent DNS name is
Ava.Do.local, Update model is both, and Update Interval is very 10 minutes.
Bluetooth parameters are defined by the following table:
Item
Number
Name Available
to User
(Y/N)
Value Type Description
1 Avalanche Enabler
Active
Y Unsigned
short
Flag to indicate that the Avalanche
Enabler is running or not
1 : Avalanche Enabler is running
0: Avalanche Enable is NOT
running (default).
2 Agent IP Address Y String The IP address of the Avalanche
Agent.
3 Agent Port Number Y Unsigned
short
The TCP/IP port number. Default
value is 1777