Datamax-O'Neil DPL Programmer’s Manual - Manual (Page 128)

Label Formatting Command Functions
120
R Set Row Offset Amount
This command allows vertical adjustment of the point where printing begins. The printer
is instructed to print label formats nnnn units above the position that the format
specifies. This feature is useful when a single format is to be printed on labels containing
preprinted information.
Syntax: Rnnnn
Where: nnnn - Is a four-digit number (0000-9999) for the row offset,
in inches/100 or millimeters/10. The default is 0.
Sample:
L
R0037
141100001000100SAMPLE LABEL
E
The sample above prints a label with a row offset amount of .37
inches, unless in metric mode.
 • If using preprinted labels where the placement of the preprint data varies from label
to label, the printed information may overlap the preprinted data.
• If printing near the TOF is important (i.e., on very small labels or in very tight
formats), it may be necessary to use the ROW ADJUST setting to shift the vertical
start of print position in the negative direction.
r
Recall Stored Label Format
This command is used to retrieve label formats stored on a memory module. Embedding
recalled labels, up to 6 levels of nesting, within a recall label is also possible.
Syntax: rnn...n