Datamax-O'Neil DPL Programmer’s Manual - Manual (Page 106)

Extended System-Level Command Functions
98
STX KI GPIO Input
Future - This command configures the GPIO input channels of the Applicator Interface
Card; see Appendix J for details.
Syntax:
KIffnspwww
Where: ff - 2 character function name abbreviation (e.g., PS [Print
Start], I1 [User Input 1], etc).
n - Pin number, where 1 – 8 is the valid range.
s - Signal type, where: L = Level; P = Positive Pulse;
and N = Negative Pulse
p
- Polarity, where: 0 = Active Low; and 1 = Active High
www
- 3 character filter pulse width, in milliseconds.
STX Kn NIC Reset
This command resets the NIC to factory defaults.
Syntax: Knx
Where:
x
- Specifies the action, where:
F = Returns the NIC to the factory default settings; or,
RH = Reports settings.
RP = Prints reports
Address
Default Values
Wired Ethernet*
Default Values
Wireless Ethernet
IP
192.168.010.026 192.168.010.001
Subnet Mask
255.255.255.000 255.255.255.000
Gateway
000.000.000.000 000.000.000.000
* Prior to introduction of the Wireless Ethernet, 192.0.0.192
was the IP default value and the Subnet Mask was 0.0.0.0.