Datamax-O'Neil DPL Programmer’s Manual - Manual (Page 31)

System-Level Command Functions
23
STX P Set Hex Dump Mode
This command instructs the printer to assume Hex Dump Mode. Instead of a formatted
product, data sent following this command will be printed in its raw ASCII format. To
capture all data, labels should be at least four inches (102 mm) long and as wide as the
maximum print width. This command has the same effect as turning “On” the printer
while depressing the FEED Key (return normal operation by manual reset).
Syntax:
P
Printer response is
data dependent
(layout may vary):
STX p Controlled Pause
This command will cause the printer to pause only after all previously received
commands are executed, often useful between label batches. (This command will not
clear the pause condition; see B).
Syntax:
p
STX Q Clear All Modules
This command instructs the printer to clear all Flash and DRAM modules (except as
noted); see the corresponding Operator’s Manual for applicable module options. All
stored data will be destroyed.
Syntax:
Q

Will not affect Module Y or the ILPC Font module.