Extron Electronics MPX 866 A User Guide - Manual (Page 121)

6. After verifying that the IP address change was successful, enter and issue the arp –d
command at the Command prompt. For example:
arp –d 10.13.197.7 removes 10.13.197.7 from the ARP table
or
arp –d* removes all static IP addresses from the ARP table.
Connecting as a Telnet Client
The Microsoft Telnet utility is available from the Command prompt. Telnet allows you to
input SIS commands to the MPX 866 A matrix switcher from the PC via the Ethernet link and
the LAN.
Access the Command prompt and start Telnet as follows:
1. On the Windows task bar, click Start > Run .
2. At the Open prompt, type command .
1. Click the OK button.
2. At the Command prompt, type Telnet and then press < Enter >. The computer returns
a display similar to the one shown in figure 72.
Microsoft (R) windows 2000 (TM) Version 5.0 (Build 2195)
Welcome to Microsoft Telnet Client
Telnet Client Build 5.00.99203.1
Escape Character is 'CTRL+]'
Microsoft Telnet>
Figure 72. Telnet Window
MPX 866 A Media Presentation Matrix Switcher • Ethernet Connection 116