Extron Electronics Annotator User Guide - Manual (Page 91)

On Screen Display
Within this section, some aspects of the on screen display can be set. The annotation,
cursor display can be set to be seen on all outputs, or where used, either group 1 or
group 2 only, or on no outputs at all. The annotation menu display can also be set to be
seen on all outputs, or where used, either group 1 or group 2 only, or on no outputs at
all. In addition where the menu is to be displayed, the length of time the menu is visible
can be set, the range being from 1.0 seconds up to 64.0 seconds (in 1 second steps), or
can be set to always on.
Aux Scaler page
The Aux Scaler page, available only if the Aux Scaler board is installed, can be
accessed by clicking the Aux Scaler link on the sidebar menu on Configuration page.
Figure 49. Aux Scaler Page
Output configuration
Depending on display device being used, the resolution and refresh rates can be set to one
of various output rates from 640x480/50 Hz to 1920x1200, including HDTV 1080p/60 Hz.
For a full table of output rates see page 19.
The output sync format can be chosen from RGBHV, RGsB, YUV bi-or tri-level sync.
Output polarity can be selected from H-/V- (default), H+/V-, H+/V+, or H-/V+.
Aspect ratio
Aspect ratio can be set to either Fill or Follow (default).
Detail
The detail setting can be adjusted for 0 to 127. 64 is the default.
Test pattern
A test pattern, useful when setting up a display, can be
selected for the drop-down list.
Annotator • HTML Operation 85