Command/response table for sis commands, Command/response table for sis, Commands – Extron Electronics Annotator User Guide User Manual
Page 50
Command
ASCII command
(host to processor)
Response
(processor to host)
Additional description
Pixel phase
Specify a value
EX^
PHAS
}
Phas
X!
*
X^]
Set pixel phase to specified value for
active input.
Increment value
E
+PHAS
}
Phas
X!
*
X^]
Increase value.
Decrement value
E
-PHAS
}
Phas
X!
*
X^]
Decrease value.
View value
E
PHAS
}
X^]
Show pixel phase.
Total pixels (RGB and YUVp/HDTV only)
Specify a value
EX&
TPIX
}
Tpix
X!
*
X&]
Set total pixels to specified value for
active input.
Increment value
E
+TPIX
}
Tpix
X!
*
X&]
Increase value.
Decrement value
E
-TPIX
}
Tpix
X!
*
X&]
Decrease value.
View value
E
TPIX
}
X&]
Show total pixels.
Active pixels
Specify a value
EX*
APIX
}
Apix
X!
*
X*]
Set active pixels to specified value for
active input.
Increment value
E
+APIX
}
Apix
X!
*
X*
]
Increase value.
Decrement value
E
-APIX
}
Apix
X!
*
X*]
Decrease value.
View value
E
APIX
}
X*]
Show active pixels.
Active lines
Specify a value
EX(
ALIN
}
Alin
X!
*
X(]
Set active lines to specified value for
active input.
Increment value
E
+ALIN
}
Alin
X!
*
X(]
Increase value.
Decrement value
E
-ALIN
}
Alin
X!
*
X(]
Decrease value.
View value
E
ALIN
}
X(]
Show active lines.
3:2/2:2 Film mode detect
Enable film mode
EX!
*1FILM
}
Film
X!
*
X1)]
Turn film mode detection on.
Disable film mode
EX!
*0FILM
}
Film
X!
*
X1)]
Turn film mode detection off.
View setting
EX!
FILM
}
X1)]
View setting.
Command/Response Table for SIS Commands
NOTE:
X!
= Input selection; 1 – 7
X^ = Pixel phase; 0-31 (default = 16)
X& = Total pixels; (±512 of the default value)
X* = Active pixels; (±512 of the default value)
X( = Active lines; (±512 of the default value)
X1) = 0 (off/disable), 1 (on/enable)
Annotator • SIS Communication and Control
44