Extron Electronics Annotator User Guide - Manual (Page 79)

Advanced Settings Tab
The Advanced Settings tab allows advanced functions to be configured. These
include test pattern selection, and advanced features, used primarily during initial setup.
Figure 39. The Advanced Settings Tab Screen
• Test Pattern — Select any of the 14 test patterns to aid setting up an output display
device. A small thumbnail of the pattern is shown on the tab (see above). Select
Off
where a test pattern is not needed.
• Aspect Ratio — Aspect ratio mode adjusts the aspect ratio of the output. The
available options are Fill, which fills the output raster, and Follow, which follows
the aspect ratio of the selected input signal. Black bars remain on either the top and
bottom or the sides. Click the radio button for the desired option (Fill or Follow).
• Advanced Features — Within this section RGB delay can be adjusted (from 0 to 5.0
seconds) in 0.1 second intervals with each click of the scroll arrows. In addition, auto
memory can be turned on or off, and switch effect can be activated. If using mini
twisted pair devices, pre-peaking can be turned on to compensate for long cable runs.
• On Screen Display — Within this section selections can be made to how annotation
display and cursor display is handled by choosing from each drop-down list. In
addition by selecting or deselecting a check box, drop shadow on annotations can be
turned on or off.
• Capture Mode — These two selectable radio buttons allow a choice of locations for
saving Quick Capture captured images to either internal or external memory.
• Menu — The menu section allows a choice of display modes (all outputs, program
only, preview only, or none) and the display duration, either from 1 to 64 seconds
(adjustable in 1 second intervals) or always on. Select as desired.
• Clock — In this section the clock display mode can be set or disabled, and the
on-screen horizontal and vertical position can be adjusted.
Annotator • SPPCP 73