Extron Electronics Annotator User Guide - Manual (Page 27)

Advanced Configuration
Within this menu auto imaging and auto memory can be turned on or off, input EDID can
be set, RGB delay value adjusted, the switch effect chosen, a test pattern selected to aid
setting up the display, and the MTP pre-peaking turned on or off. In addition the internal
temperature can be read, the touch panel display can be calibrated, and the unit can be
reset to factory default settings.
1. Press Next to enter the first sublevel, Auto Image. The current active input and setting
status is displayed.
NOTE: At any submenu, if the input is incorrect, press the desired input button, and
then proceed with the setting adjustment.
2. With the applicable input showing, rotate the right Adjust knob ({)
to turn the Auto Image on or off.
3. Press Next to enter the next sublevel, Auto Memories, and rotate either Adjust knob
([{) to turn the Auto Memory on or off.
4. Press Next to enter the next sublevel, Aspect Ratio, and rotate either Adjust knob
([{) to select Fill or Follow.
5. Press Next to go to the next sublevel (Input EDID), or press Next
repeatedly to get to any applicable level. At each level, rotate
the Adjust knobs (right only or both) as needed to change the
settings to the desired value.
NOTES: • The Input EDID setting adjustment applies only to the VGA and DVI inputs.
See figure 12 for resolution and refresh rate details.
• For some settings (such as panel calibration) follow on-screen instructions.
• The internal temperature is a “read-only” screen. No adjustment is possible.
The following test pattern settings are available:
None (default), Split Color Bars (8), Crosshatch 4x4, 32 Level Grayscale, Ramp, Alternating
Pixels, Whitefield, Crop, 1.33 Aspect ratio, 1.78 Aspect ratio, 1.85 Aspect ratio, 2.35
Aspect ratio, Safe Area, Blue Mode.
Color Bars Split Grayscale 4x4 Crosshatch Alternating
Pixels
Crosshatch
1.78 Aspect 1.85 Aspect 2.35 Aspect Crop
Ramp White Field
1.33 Aspect Safe Area 5% 10%
NOTE: The test patterns may vary based on the output rate selected. For example, if
a 4:3 rate is selected, then the 4:3 crosshatch (32x24) and aspect ratio crop
patterns appear. The raster border is independent of the aspect ratio, always
surrounding the active area of the screen.
If a touchpanel screen is attached to the Annotator, the touch accuracy can be calibrated
using the Calibrate Panels setting in the Advanced configuration menu.
1. Within the Advanced Configuration menu press Next repeatedly to cycle to the
Calibrate Panels submenu.
2. Press the Size button and observe the touchpanel screen. A cross appears in the upper
left corner. Tap the screen at the cross, and repeat at each cross.
Auto Image
Input #2 On
Input EDID
1024x768 60.0Hz
Annotator • Operation 21