Rs-232 driver configuration, Usb port connections – Extron Electronics Annotator User Guide User Manual
Page 37
3.
Select the
USB Configuration
tab and sort by device type, manufacturer, and
version.
4.
Click
Update Modules
to locate a device module in the Available Modules section
5.
Select a module and click
Add Module
. The added module appears in the Loaded
Modules on Annotator section.
NOTE: Click
Comm Sheet
after selecting a device in the Available Modules section to
see communication information for the selected device driver.
To delete a touchpanel driver:
1.
From the
Tools
menu, select
Device Module Configuration
.
2.
In the Loaded Modules on Annotator section, select the device module to be deleted.
3.
Click
Remove Module
. This removes the device module from the Annotator.
RS-232 Driver Configuration
To load a touchpanel driver:
4.
Select the
RS-232 Configuration
tab. Sort by device type, manufacturer, and
version.
5.
Click
Update Modules
to locate a device module in the Available Modules section
6.
Click
Load to Top Port
or
Load to Bottom Port
to load the driver to the RS-232
port with the connected touchpanel.
NOTE: Click
Comm Sheet
after selecting a device in the Available Modules section to
see communication information for the selected device driver.
To delete a touchpanel driver:
1.
From the
Tools
menu, select
Device Module Configuration
.
2.
In the Loaded Modules on Annotator section, select the module to be deleted.
3.
Click
Remove Module
. This removes the device module from the Annotator.
USB Port Connections
Touchpanels can be connected via the two rear panel USB ports. By connecting multiple
USB hubs (see figure 20), up to 20 devices can be connected.
A number of common touchpanels are automatically supported. A mix of size and vendor
types can be connected simultaneously, but unsupported devices may cause adverse
af
The USB ports also support standard USB keyboards and mice.
Before use, panel calibration is advised (see
in this section).
Using a suitable USB A cable, connect a touchscreen device or hubs to the either of the
two USB A ports on the rear panel of the Annotator. Do not connect more than three
hubs in line (three deep).
1 2 3 4
Annotator
USB #1
Hubs
1 2 3 4
1 2 3 4 1 2 3 4
1 2 3 4
Figure 20.
Connect USB Hubs for Multiple Devices
Annotator • On Screen Annotation
31