Extron Electronics Annotator User Guide - Manual (Page 47)

X1@ = Internal temperature (in degrees Celsius)
X1# = Horizontal and vertical frequencies (format is three digit with single decimal
and leading zeros for example, 075.3)
X1$ = Disable (0), or enabled mode 1 (1) or enabled mode 2 (2)
X1% = Picture adjustment — 0 to 127 (default 64)
X1^ = H or V position (zero location is 2048, and limits are ± the output resolution)
X1& = H or V size (0 to 200% of the output area, in single pixel increments)
X1* = Zoom (100 to 500%)
Default for low resolution video = 111%
Default for high resolution video = 100%
X1( = Pan — 0 to 200 (default = 100, center point)
X2) = Test patterns:
0 = off (default) 8 = Crop 7 = white field
1 = color bars 9 = 1.33 aspect ratio
2 = crosshatch 10 = 1.78 aspect ratio
3 = 4x4 crosshatch 11 = 1.85 aspect ratio
4 = grayscale 12 = 2.35 aspect ratio
5 = ramp 13 = safe area
6 = alternating pixels 14 = blue mode
X2! = Scaler resolution:
1 = 640x480 14 = 1365x1024
2 = 800x600 15 = 1440x900
3 = 852x480 16 = 1400x1050
4 = 1024x768 17 = 1680x1050
5 = 1024x852 18 = 1600x1200
6 = 1024x1024 19 = 1920x1200
7 = 1280x768 20 = 480p
8 = 1280x800 21 = 576p
9 = 1280x1024 22 = 720p
10 = 1360x765 23 = 1080i
11 = 1360x768 24 = 1080p
12 = 1365x768 25 = 2048x1080
13 = 1366x768 26 = 1080p CVT
X2@ = Output refresh rate:
1 = 23.98 Hz 6 = 50 Hz
2 = 24 Hz 7 = 59.94 Hz
3 = 25 Hz 8 = 60 Hz (default)
4 = 29.97 Hz 9 = 75 Hz
5 = 30 Hz
X2# = Output polarity:
0 = H-/V- (default)
1 = H-/V+
2 = H+/V-
3 = H+/V+
X2$ = Output sync format:
0 = RGBHV (default)
1 = RGsB
2 = YUV bi-level
3 = YUV tri-level
Annotator • SIS Communication and Control 41