Output configuration – Extron Electronics Annotator User Guide User Manual
Page 26
Output Configuration
Using this menu, resolutions, refresh rates, output signal types, and sync polarity can be
selected and adjusted for an output. See the table below for resolution and refresh rates.
1.
Press Next to bring up the Resolution submenu. In this submenu, the resolution and
refresh rate can be adjusted.
2.
Rotate the left front panel Adjust knob ([) to adjust the resolution value, and rotate
the right Adjust knob ({) to adjust the refresh rate.
Resolution
23.98 Hz 24 Hz 25 Hz
29.97 Hz
30 Hz
50 Hz 59.94 Hz
*60 Hz 75 Hz
640x480
X
X
X
800x600
X
X
X
852x480
X
X
X
1024x768
X
X
X
1024x852
X
X
X
1024x1024
X
X
X
1280x768
X
X
X
1280x800
X
X
X
1280x1024
X
X
X
1360x765
X
X
X
1360x768
X
X
X
1365x768
X
X
X
1366x768
X
X
X
1365x1024
X
X
X
1440x900
X
X
X
1400x1050
X
X
1680x1050
X
X
1600x1200
X
X
1920x1200
X
X
480p
X
X
576p
X
720p
X
X
X
X
X
X
1080i
X
X
X
1080p
X
X
X
X
X
X
X
X
2048x1080
X
X
X
X
X
X
X
X
1080p CVT
X
Figure 12.
Output Resolution/Refresh Rate Table
3.
Press Next to enter the next submenu, Output Type. Within this submenu the output
signal type (RGBHV, RGsB, YUV bi-level, or YUV tri-level) can be selected.
4.
Rotate either front panel Adjust knob ([{) to select the output signal type.
5.
Press Next to enter the next submenu, Sync Polarity. Within this submenu, the Sync
Polarity can be set (H- V-, H+ V-, H+ V+, or H- V+).
6.
Rotate either front panel Adjust knob ([{) to select the sync polarity.
NOTE:
An incorrect sync polarity setting will result in the loss of the output image.
7.
Press Next or Menu to return to the Output Configuration.
Annotator • Operation
20