Extron Electronics Annotator User Guide - Manual (Page 70)

SPPCP Menus
File menu
Click on this to open a drop-down menu displaying six selectable
options: Connect, Disconnect, Save
Configuration..., Restore Configuration...,
File Manager, and Exit
.
• Connect — Select this to reconnect the Annotator (or connect
a new device) when it has been disconnected from the Signal Processing Products
Control Program. Follow the steps in the section “
Starting the SPPCP. ”
• Disconnec t — Select this to disconnect the unit from the Signal Processing Products
Control Program. The SPPCP remains open, but items on the main window are
inactive (grayed out) and configuration via the SPPCP is not available.
• Save Configuration.. . — Select this to save the current configuration.
A secondary window opens allowing choice of items to save, and selecting a folder
location for the saved xxx.cfg files.
NOTE: Save these files to the root directory of the Annotator to be accessible later.
• Restore Configuration... — Select this to restore a saved configuration. A
secondary window opens allowing a choice of which folder to restore the files from. A
pop-up confirmation window opens allowing the action to be completed or cancelled.
• File Manager — Select this to load the Extron IP Link ® File Manager application. This
is used in uploading and downloading files to and from IP Link-enabled devices.
NOTE: This option becomes enabled when the File menu is accessed after
installing File Manager. In order to use this option, download the IP Link
File Manager application at
www.extron.com .
• Exit — Select this to exit the control program. This disconnects and closes the SPPCP.
Options menu
Click on this to open a drop-down menu displaying two selectable options:
Show Splash Screen, and Display Errors on Status Bar.
• Show Splash Screen — Select this to show the Extron
Signal Processing Products Control Program splash
screen upon startup. Deselected, the program opens
immediately to the Select Connection Type window.
• Display Errors on Status Bar — Select this
to display any operation errors on the status
bar at the bottom of the window.
Annotator • SPPCP 64