Extron Electronics Annotator User Guide User Manual
Page 56
Command
ASCII command
(host to processor)
Response
(processor to host)
Additional description
Advanced Configurations
Test pattern
Set test pattern
EX2)
TEST
}
Test
X2)]
Select test pattern
X2)
.
View test pattern
E
TEST
}
X2)]
View which test pattern is used.
RGB delay time
Set value
EX3&
VDLY
}
Vdly
X3&]
Set RGB delay.
View setting
E
VDLY
}
X3&]
View RGB delay setting.
Switch effect
Cut
E
0SWEF
}
Swef0
]
Sets the switch effect to cut.
Fade
E
1SWEF
}
Swef1
]
Sets the switch effect to fade
through to black.
View setting
E
SWEF
}
0
]
(or 1
]
)
View effect setting.
Aspect Ratio mode
Enable Fill mode
E
1Aspr
}
Aspr1
]
Set aspect ratio to Fill.
Enable Follow mode
E
2Aspr
}
Aspr2
]
Set aspect ratio to Follow (default).
View aspect ratio setting
E
Aspr
}
X5%]
Show current aspect ratio
MTP Pre-peaking
Enable
E
1OPEK
}
Opek1
]
Enables pre-peaking on the MTP
output.
Disable
E
0OPEK
}
Opek0
]
Disables pre-peaking.
View setting
E
OPEK
}
X1)]
View pre-peaking setting.
Front panel lockout (executive mode)
Enable Mode 1
1X
Exe1
]
Limited front panel adjustments.
Enable Mode 2
2X
Exe2
]
Lock out entire front panel.
Disable
0X
Exe0
]
Adjustments and selections can be
made from front panel.
View front panel lock status
X
X1$]
Show executive mode status.
NOTE:
For full lock mode details see the “Setting the Front Panel Locks (Executive Modes)” section.
Picture in Picture
PIP on/off
PIP on
EX!
PIP
}
Pip
X!]
Turn PIP on and display input
X!
.
PIP off
E
0PIP
}
Pip0
]
Turn PIP off.
View PIP status
E
PIP
}
X!]
View PIP window selection.
NOTE:
When PIP is enabled, all picture control commands apply to the image in the PIP window.
Swap PIP
Swap
%
Tke
]
Swap PIP/main window content.
NOTE:
X!
= Input selection 1 – 7
X1)
= off/disable (0), on/enable (1)
X1$ = Disabled (0), or enabled mode 1 (1) or enabled mode 2 (2)
X2)
= Test patterns: 0 = Off (default), 1 = Color bars, 2 = Crosshatch, 3 = 4x4 Crosshatch, 4 = Grayscale,
5 = Ramp, 6 = Alternating Pixels, 7 = White field 8 = Crop, 9 = 1.33 Aspect ratio,
10 = 1.78 Aspect ratio, 11 = 1.85 Aspect ratio, 12 = 2.35 Aspect ratio, 13 = Safe area, 14 = Blue mode
X3&
= RGB delay — 0 to 50, in 0.1 second increments (default is 05 = 0.5 seconds)
X5%
= Aspect ratio, 1 = Follow, 2 = Fill
Annotator • SIS Communication and Control
50